This site has limited support for your browser. We recommend switching to Edge, Chrome, Safari, or Firefox.


DX1 Mono LCD Screen with cable


Monochrome LCD screen for the EPAX DX1 Printer.  

DX1 uses a 6.6" 4K mono screen.


    • LCD screen
    • screen cable
    • 1x precut tape (to be applied around the screen after installation)


    ALWAYS make sure your vat is free from any debris and that the build plate has nothing on it before starting a new print job.  Monochrome screens are more expensive due to being produced in smaller volumes only for 3D printing.

    Using this screen with other similar 3D printers is NOT supported.

    Replacing your screen always involved re-leveling your build plate.

    You can reference below general guide for screen replacement too: